Idiomas disponibles
Idiomas disponibles
However, it is no longer expedient for thicker
materials. In this case, it is better to prepare
a joint as shown below, in which the edge of
the plate is angled (Fig. V).
V
Fillet weld connections
A fillet weld is created if the workpieces are
perpendicular to each other. The weld should
be shaped like a triangle with sides of equal
length and a slight fillet (Fig. W, X).
Welds on an inner edge
The preparation for this weld joint is very
simple and is carried out for thicknesses of
5 mm. The dimension "d" needs to be
reduced to a minimum and should always be
less than 2 mm (Fig. W).
W
However, it is no longer expedient for thicker
materials. In this case, it is better to prepare
a joint as shown in Figure V, in which the
edge of the plate is angled.
X
Overlap welds
The most common preparation is that with
the straight weld edges. The weld can be
released using a standard angle weld seam.
Both workpieces must be brought as close to
each other as possible, as shown in Fig. Y.
Y
z Maintenance
Remove dust and contamination from
„
the device regularly.
Clean the device and accessories
„
with a fine brush or a dry cloth.
z Information about recycling
and disposal
Don't throw away – recycle!
Please return this device, accesso-
ries and packaging to your local
recycling depot.
87
GB/MT
