Idiomas disponibles
Idiomas disponibles
the welding power source to
defrost pipes.
Please note:
The light radiation emitted by
„
the arc can damage eyes and
cause burns to the skin.
Arc welding creates sparks
„
and drops of melted metal.
The welded workpiece starts
to glow and remains hot
for a relatively long period.
Therefore, do not touch the
workpiece with bare hands.
Arc welding can cause
„
vapours to be released that
may be hazardous to health.
Be careful not to inhale these
vapours.
Protect yourself from the harm-
„
ful effects of the arc and keep
people that are not involved
in the work away from the arc
maintaining a distance of at
least 2 m.
ATTENTION!
During the operation of the
„
welder, other consumers may
experience problems with the
voltage supply depending on
the network conditions at the
connection point. In case of
doubt, please contact your
energy supply company.
76
GB/MT
Do not use
During the operation of the
„
welder, other devices may
malfunction, e.g. hearing aids,
cardiac pacemakers, etc.
z Potential hazards during
arc welding
There are a series of potential
hazards that can occur during
arc welding. It is therefore par-
ticularly important for the welder
to observe the following rules to
avoid endangering him/herself
and others and to prevent dam-
age to people and the device.
Work on the voltage side, e.g.
„
on cables, plugs, sockets etc.,
may only be carried out by
qualified electricians accord-
ing to national and local
regulations.
In the event of accidents,
„
disconnect the welder from the
mains voltage immediately.
If electrical contact voltages
„
occur, switch off the device
immediately and have it
checked by a qualified electri-
cian.
Always ensure good electrical
„
contacts on the welding current
side.
Always wear insulating gloves
„
on both hands during welding
