Scheppach HS80 Manual De Instrucciones página 37

16. Troubleshooting
Fault
Blade dissolves after
switching off the engine
Engine will not start
Motor will not work, the
fuse is active
Fire marks on the
cutting surface
 www.scheppach.com /  [email protected] /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Possible causes
To slightly tightened fastening nut
Failure mains fuse
Defective extension cable
Connections on motor or switch not
in order
Motor or switch faulty
Cross section of the extension
cable is not sufficient
Overload by a blunt saw blade
Blunt saw blade
Wrong saw blade
Action
Tighten the right hand thread nut
Check mains fuse
Replace extension cord
Repair by electrical specialist
Repair by electrical specialist
See „Electrical connection"
Change saw blade
Have saw blade sharpened (only by an authorised
sharpening specialist) or change it
Change saw blade
GB | 37