Implementing; Maintenance; Troubleshooting - Scheppach wox d 700 Manual Del Usuario

Commissioning
• Before commissioning the safety.
• All protective and auxiliary devices shall be mounted.
• changeover, adjustment, testing and cleaning work carried
out with the engine off. Pull the power plug and wait
stalling of the rotating tool.
• The saw is solely for the cross-sectional cutting of firewood
with max. 1 meter length constructed
• Regardless of the timber diameter Only one piece with min.
Ø 60 mm are placed on the rocker. In the seesaw of wox
d700sl several logs may be loaded simultaneously, but only
so many that the lid can be closed safely
• Functional test before starting work.
• wooden rocker in place.
• pivot the rocker to the saw blade with both hands on the
handle.
• Then bring the rocker to the starting position.
• The to be sawn wood may not be fixed by hand.
Tractor mounting
• To grow the circular saw cutting firewood in the longitudinal
direction of the 3-point hydraulic system of the tractor.
• The spline stub must be covered with the protective cap.
• The saw must only be operated with the overload clutch. Fig.1
(Included) The Überlastkupplun can accelerate or retard the
speed of development of noise.
• The propeller shaft during operation with the chain secured
against spin.
• The propeller shaft after uncoupling from the tractor on the
retaining clip.
• When leaving work the tractor-turn and remove the key.
• Use correct PTO shaft. We recommend the scheppach
propeller shaft W100 Item No. 05018101.

Maintenance

• Maintenance, repair and cleaning operations and
malfunctions only when the PTO (power plug) make.
Blade change
• The blade change can be made only in firewood cutting
position.
• Side cover open.
• The locking pin (1) through the lower blade guard to lock
the saw blade stuck.
• M12 bolt the saw blade with the supplied hexagonal
wrench (2) solve
• Saw blade change
• M12 screw tighten with spanner fixed to 90 Nm.

TROUBLESHOOTING

To repair disfunctiones switch off the machine. Pull out power supply.
Cause
Upon switching off the saw does not slow down.
Brake board defect
Electrotechnical maintenance works should only be carried out by an electronics technician!
On removal of the machine the local legal regulations have to be abided by.
Abb.1
Remedy
Renew brake board
�
1
�
1
Seite:59