Tabla de contenido
Idiomas disponibles
Idiomas disponibles
You can read more about this in
"Battery charging state indicator (while
charging)".
Charging the battery (with wall
mounting) (Fig. 12)
There are 2 ways to store and charge
the vacuum cleaner in the supplied wall
bracket.
Before charging the battery for the first
time, you must read the information in
"Installation and connection" –
"General battery information".
You will need a suitable location near
a free power socket for mounting the
appliance on the wall.
Wall mounting (Figs. 13 + 14)
The supplied wall bracket has a
mounting plate with a bag of screws
attached to the back.
Attach the mounting plate to the point
on the wall where you want the wall
mounting to be.
Remove the bag of screws.
Press the release catch at the bottom
of the wall bracket (Fig. 13).
Remove the mounting plate from the
wall bracket by sliding it downward
(Fig. 14).
Attaching the mounting plate
(Figs. 15 + 16)
2 plugs and 2 T20 TORX screws are
supplied for attaching the mounting
plate to the wall.
You will also need a battery-operated
screwdriver or a drill (with a drilling
diameter of 1/4" (6 mm)).
Depending on how you decide to
configure your vacuum cleaner, select a
distance of 17 3/4" (45 cm) or 38
9/16" (98 cm) between the bottom edge
of the mounting plate and the floor (Fig.
15).
Be careful not to damage any cables
laid in the wall.
Attach the mounting plate to the wall
(Fig. 16).
Attaching the charging cable to the
wall bracket (Figs. 17, 18 + 19)
A cable compartment is located on the
underside of the wall bracket.
Press both release catches on the
underside of the wall bracket and
remove the cable compartment cover
(Fig. 17).
Plug the supplied charging cable into
the opening from above (Fig. 18).
Lay the charging cable in its guide
(Fig. 18).
Refit the cover and lock the cable
compartment (Fig. 19).
Connecting the accessories holder
(if required) (Fig. 20)
An accessories holder is supplied for
storing the three-piece accessory set
on the wall bracket (see "Using the
accessories supplied").
Push the accessories holder on to the
wall bracket as far as it will go.
en-CA
57
Tabla de contenido
