Tabla de contenido
Idiomas disponibles
Idiomas disponibles
References to figures
The figures referred to in the sections
are on the fold-out pages at the end of
these operating instructions.
Installation and connection
Assembling the vacuum cleaner
(Fig. 01)
You can assemble the vacuum cleaner
in 2 different ways.
You can place the suction tube either
above or below the PowerUnit.
Take care to assemble the vacuum
cleaner exactly as shown in the
diagram.
The advantages of placing the
PowerUnit at the bottom of the
vacuum cleaner are as follows:
- Secure self-standing function possible
(see "Use" – "Self-standing function for
short pauses in vacuuming")
- Ergonomic (reduced strain on the
wrist)
- Convenient cleaning of large surfaces
The advantages of placing the
PowerUnit at the top of the vacuum
cleaner are as follows:
- Convenient cleaning underneath
furniture
- PowerUnit can be removed quickly
Using the PowerUnit solo (Fig. 02)
The PowerUnit can be used on its own
without the suction tube and
Electrobrush as a quick way of
vacuuming up crumbs and lint in
specific areas.
Useful tip: This configuration is
particularly suitable when using the
three-piece accessory set (see "Using
the accessories supplied").
Connecting the Comfort handle
(Fig. 03)
Depending on how you decide to
configure your vacuum cleaner, you can
connect the Comfort handle to either
the suction tube or the PowerUnit.
Push the Comfort handle down on to
the suction tube connection from
above until it audibly clicks into place
(left image detail).
Slide the Comfort handle along the
guide line on the dust container
handle and down on to the PowerUnit
connector from above until it audibly
clicks into place (right image detail).
Switch off the vacuum cleaner using
the On / Off switch on the front of the
Comfort handle if you want to
separate the sections.
Press the release catch and remove
the Comfort handle by pulling it
upward (Fig. 04).
Connecting the PowerUnit and the
suction tube (Fig. 05)
Depending on how you decide to
configure your vacuum cleaner, the
suction tube is located either above or
below the PowerUnit.
Slide the suction tube along the guide
line on the dust container handle and
down on to the PowerUnit connector
from above until it audibly clicks into
place (left image detail).
en-CA
55
Tabla de contenido
