Chicago Pneumatic BOOSTER 8000 Manual Del Usuario página 12

1. The tension selector must be disconnected !
2. How to connect your Booster
2A. Starting in 12V:
Connect the red clamp (+) to the positive terminal (+)
of the battery, then connect the Blue clamp (-) to the
negative terminal (-) of the battery.
2B. Starting in 24V:
-> Read page 12: detection of 24V
□ If the batteries are side by side:
Connect the red clamp (+) to the positive terminal
(+) of the battery, then connect the blue clamp (-) to
the negative terminal (-) of the other battery.
□ If the batteries are on both sides of the vehicle:
Connect the red clamp (+) to the positive terminal (+)
of the battery, then connect the blue clamp (-) to the
mass of the vehicle.
3. Selection of the voltage
Select the voltage of the vehicle to start
-> from this moment there is current on the clamps.
- 12 -