Hilti DX 76 Manual Del Usuario página 25

▶ Do not dismantle the fastening tool while it is hot. Allow the fastening tool to cool down.
Risk of explosion with cartridges
▶ Use only cartridges that are suitable and approved for use with the fastening tool.
▶ Remove the cartridge strip when you are going to take a break and when you have finished the job, and
before you transport the fastening tool.
▶ Do not use force to remove fasteners and/or cartridges from the magazine strip or the fastening tool.
▶ Store unused cartridges in accordance with the storage specifications for cartridges for powder-actuated
fastening tools (e.g. dry, temperature between 5 °C and 25 °C) in a secured storage facility.
▶ Do not leave unused or partly used cartridge strips lying around. Collect the used cartridge strips and
store the cartridge strips at a suitable, secured location.
▶ Follow all instructions relating to safety, handling and storage in the safety data sheet of the cartridges.
3 Description
3.1 Overview illustration, DX 76
3.2 Intended use
The product described is a fastening tool for driving nails, studs and fasteners into steel.
Use the product only in combination with the equipment designed for use with the fastening tool. Fastener
guides, piston and fasteners must be compatible with one another.
Use the product only with spare parts and accessories from Hilti and with cartridges and fasteners from
Hilti, or other suitable cartridges and fasteners.
3.3 Requirements to be met by cartridges
WARNING
Risk of injury by unexpected explosion!
requirements can lead to a build-up of unburned powder. A sudden explosion and severe injuries to the
operator and bystanders can result.
▶ Use only cartridges that meet the minimum safety requirements of your local statutory regulations!
▶ Adhere to the maintenance intervals as stated and have the fastening tool cleaned regularly by Hilti-
Service!
Use only the Hilti DX cartridges listed in this table, or other suitable cartridges that are compliant with the
minimum safety requirements:
*282471*
1
Use of cartridges that do not meet the minimum safety
282471
Fastener magazine MX 76
@
Contact pin
;
Mounting points for splinter guard
=
Cycling grip
%
Cartridge barrel (insertion)
&
Loading status control window
(
Adjusting knob for driving energy
)
Indicator for energy control
+
Padded end cap
§
Housing
/
Grip pad
:
Trigger
∙
Piston-guide locking lever
$
Piston guide
£
Splinter guard
|
Fastener stop piece
¡
Air vents
Q
Fastener guide X-76-F-15
W
Splinter guard for X-76-F-15
E
Piston
R
Piston stopper
T
English 19