Beurer BM 57 Instrucciones De Uso página 27

• To carry out a blood pressure measurement, make sure you
are sitting comfortably with your arms and back leaning on
something. Do not cross your legs. Place your feet flat on
the ground.
• To avoid falsifying the measurement, it is important to remain
still during the measurement and not to speak.
Performing the blood pressure measurement
As described above, attach the cuff and adopt the pos-
ture in which you want to perform the measurement.
• Press the START/STOP button
the blood pressure monitor. All display
elements are briefly displayed.
The blood pressure monitor will begin the
measurement automatically after 3 sec-
onds. The measurement is taken during the
inflation phase.
You can cancel the measurement at any time by
pressing the START/STOP button
As soon as a pulse is found, the pulse symbol
displayed.
• The systolic pressure, diastolic pres-
sure and pulse rate measurements are
displayed.
to start
.
will be
27
• EE appears if the measurement could
not be performed properly (see chapter
10 "Error messages/troubleshooting").
Repeat the measurement.
• Now select the desired user memory by pressing the
M1 or M2 memory buttons. If you do not select a user
memory, the measurement is stored in the most re-
cently used user memory. The relevant
appears on the display.
• Press the START/STOP button
blood pressure monitor. The measurement is then
stored in the selected user memory.
• If the device is not switched off manually, it will switch
off automatically after approx. 1 minute.
If Bluetooth ® data transfer has been activated, data is
transferred after having confirmed the user memory and
pressing the START/STOP button
The Bluetooth symbol flashes on the display. The blood
®
pressure monitor now attempts to connect to the app for
approx. 30 seconds.
The Bluetooth symbol stops flashing as soon as a
®
connection is established. All measurement data is auto-
matically transferred to the app. Once the data has been
successfully transferred, the device switches off.
or symbol
to switch off the
.