Adjustments And Maintenance; Setting The Swinging Arm; Clutch Adjustment - Tecno-gaz ORION Serie Manual De Uso

TECNO-GAZ
See drawing 157
See drawing 157
Operation and
maintenance manual
pieces is turned downwards. The hand-pieces must be free and not
burdened by other material being sterilized.
Damaged hand-pieces must no longer be used.

7 Adjustments and maintenance

7.1 Setting the swinging arm

The Product is sold already balanced and does not require further
adjustment. In the event of the spring swinging arm becoming stiff or
loose over time, mechanical intervention is possible by regulating the
compression of the internal spring.
Manually move the cover (5) forwards. Fit a pin (6) with diameter of 8
mm in the holes of the ring nut and turn in the direction indicated by the
arrows to increase/decrease the load on the spring.
If the swinging arm drops, this means the elastic force of the spring is
insufficient:
- turn the lever upwards and release the spring.
If the swinging arm lifts up, this means the elastic force of the spring is
too high:
- turn the lever upwards and release the spring.
At the end of adjustment, manually reposition the cover (5) in its original
position.
The swinging movement of the arm can also be adjusted upwards.
The Product is sold with maximum set swinging movement. If the
swinging movement is to be reduced upwards, manually move the
cover (5) forwards and insert a pin (7) with max diameter 5mm in the
second ring nut. By turning the pin downwards, the swinging movement
can be reduced until it is in horizontal position.
The swinging movement downwards cannot instead be changed.
At the end of adjustment, manually reposition the cover (5) in its original
position.

7.2 Clutch adjustment

The brakes are set during installation. Like all the other mechanical
parts, the brakes are also subject to wear.
If the Product does not remain in a stable position, the braking force will
have to be adjusted by means of the brake screws.
MU_025 04/02/16
Rev.2 Page 17 of 28
EN