Transport; Transporting The Appliance - AL-KO solo 127597 Manual Del Usuario

GB
Malfunction
Rechargeable battery
operating time is sig-
nificantly shorter.
Rechargeable bat-
tery cannot be
charged.
Cockpit is switched
on, but the motor is
not running.
Error display on the
cockpit lights up.
Error messages on
the Smart Button

11 TRANSPORT

11.1 Transporting the appliance

IMPORTANT! Risk of damage to the mower
mechanism. At the lowest cutting height, the
mower mechanism can be damaged by driving
over steps, edges or kerbs.
■
Set the cutting height to the highest level for
transport.
1. Stop the mower mechanism and wait until it
has come to a standstill.
2. Set the highest cutting height.
3. Turn the key switch to the OFF position (posi-
tion 0).
38
Cause
Cutting blade is blunt.
Cutting height is too low.
Grass is too long or too wet.
Mowing speed is too high.
Mowing with full grass catcher
The service life of the battery
has expired.
Rechargeable battery contacts
are dirty.
Battery or charger is defective.
Battery is too hot.
The power supply is switched
off at the key switch.
Battery not installed correctly.
Causes and remedies: see chapter 3.9 "Smart Button (03)*", page 28.
Remedy
Have the cutting blade sharpened at one of
the manufacturer's service centres.
Raise the cutting height
Improve the conditions: Let it dry, set a
higher cut
■
Reduce the mowing speed
■
Clean the discharge channel/housing,
the cutting blade must rotate freely.
Empty the grass catcher and clean the dis-
charge channel.
Replace the battery. Use only genuine ac-
cessories from the manufacturer.
Clean the battery contacts with a non-metal-
lic object and spray with a contact spray.
Important: Do not short-circuit the battery
contacts with a metallic object!
Order replacement parts from the manufac-
turer.
Allow the battery to cool down.
Switch the power supply on at the key
switch.
Install the battery correctly.
Transporting the appliance between two
working areas
■
Move the appliance to the working area with
the mower mechanism set to the highest cut-
ting height.
■
Engage the wheel drive* for easier manoeuvring.
■
Use the handlebar and front carrying handle*
to carry the appliance.
* depending on the model, see technical data.
Transporting the appliance in a vehicle
■
Remove the batteries.
■
Fold down the handlebar.
■
Secure the appliance in the vehicle against
falling over and sliding.
Transport
495504_a