Repair Work; Usb Port (18); Help In Case Of Malfunction - AL-KO solo 127597 Manual Del Usuario

Help in case of malfunction

9.5

Repair work

WARNING! Risk of injury during repair
work. Improper repairs can lead to serious inju-
ries and damage to the appliance.
■
Have repair work performed by the manufac-
turer's service centres and authorised spe-
cialist companies only!
In the following cases, contact one of the manu-
facturer's service centres:
■
Motor no longer starts.
■
Appliance has moved onto an obstruction.
■
Cutting blade and/or motor shaft are bent.
■
Appliance vibrates and does not run smoothly.
■
Batteries are discharged or damaged.
9.6

USB port (18)

The USB port (18/1) is installed on all the lawn-
mowers described in this operating manual, but
can only be used for software updates on smart
Malfunction
Engine does not
start.
Engine loses power. Rechargeable battery is flat.
Motor stops during
mowing.
Grass catcher is not
filled sufficiently
495504_a
Cause
The power supply is switched
off at the key switch.
Rechargeable battery missing
or not seated correctly.
Rechargeable battery is flat.
Cutting blade is blocked.
Cables or switches are defec-
tive.
Cutting blade is blunt.
Too much grass in the ejector.
Cutting blade is blunt.
Motor is overloaded.
Grass is wet.
Grass catcher is clogged.
Too much grass in the dis-
charge channel or housing.
lawnmowers. It is not suitable for use for charging
of batteries.
IMPORTANT! Risk of damage to the appli-
ance. The batteries of mobile devices (e.g.
smartphones) will be destroyed if they are
plugged into the USB port.
■
Do not plug any mobile devices with battery
into this port.
10 HELP IN CASE OF MALFUNCTION
CAUTION! Risk of injury. Sharp-edged
and moving appliance parts can lead to injury.
■
Always wear protective gloves during mainte-
nance, care and cleaning work!
NOTE For malfunctions that are not listed in
this table or that you cannot resolve yourself,
please contact our customer service.
Remedy
Switch the power supply on at the key
switch.
Install the battery correctly.
Charge the battery.
■
Free the blade of obstructions.
■
Start the lawnmower on short grass.
Do not operate the appliance! Contact a
service centre of the manufacturer.
Charge the battery.
Have the cutting blade sharpened at one of
the manufacturer's service centres.
■
Remove the grass.
■
Clean the impact flap.
Have the cutting blade sharpened at one of
the manufacturer's service centres.
Switch off the battery lawnmower, set on
level ground or short grass and restart.
Allow the lawn to dry.
Clean the grid of the grass catcher.
■
Clean the discharge channel/housing
■
Correct cutting height
GB
37