During Use - Dräger UCF 6000 Instrucciones De Uso

4.3

During use

4.3.1 Functions of the Dräger UCF 6000/Dräger UCF 7000
Switching the thermal imaging camera on and off
Press the ON/OFF key for approx. 3 seconds to switch on the ther-
mal imaging camera.
The startup screen appears, then the infrared image is displayed.
The thermal imaging camera is in standard application mode.
NOTICE
i i
The startup screen displays the identification of the thermal
imaging camera (order number, serial number and software
version).
The thermal imaging camera switches to standby mode if it is
not held at the handgrip (see chapter 3.3 on page 29). Only
the display, but not the thermal imaging camera, is switched
off in standby mode. Hold the camera at the handgrip to
switch on the display again.
This function can be disabled in the PC software. Simply
remove the "Standby Detection Enabled" checkmark in
"Camera - Settings."
To switch the thermal imaging camera off, press the ON/OFF key
until 3-2-1 appears on the display and the thermal imaging camera
switches off.
Dräger UCF 6000/7000
Activating the "Freeze" function
Hold down the pistol key to activate the "Freeze" function.
The picture remains "frozen" and does not change as long as the
pistol key is pressed. The Dräger UCF 7000 saves the picture at
the same time.
Using the laser pointer
CAUTION
!
The laser light may be dangerous for the eyes.
Do not stare directly into the laser beam! Do not point the
laser on the head of persons! Always switch off the laser
pointer when it is not used
The laser pointer is activated differently for the two thermal imaging
cameras:
Dräger UCF 6000:
Press and release the laser pointer key.
Dräger UCF 7000:
Press and release the right arrow/laser pointer key.
The laser pointer symbol is displayed in the bottom display bar. Point
the camera towards the object to be marked.
Briefly press the same key again to switch off the laser pointer. The
laser pointer symbol in the bottom display bar disappears.
4.3.2 Additional functions of the Dräger UCF 7000
The functions of the Dräger UCF 7000 can be accessed using the
4-way key.
Use
35