To Prepare The Cutting Guide; To Use The Rail Fixture - Husqvarna K 1270 II Manual Del Usuario

1. Attach the rail fixture to the rail. Tighten the handle
fully.
2. Install the product on the rail fixture with the right
side of the product against the rail fixture.
Note:
It is also possible to install the product with the
left side against the rail fixture, but we recommend to
use the right side when possible.

To prepare the cutting guide

Note:
The first time you use the rail system, you must
cut the cutting guide.
The cutting guide helps the operator to put the cutting
blade in correct position for the cut.
1. Fold out the cutting guide.
2. Put the cutting guide parallel to the rail.
3. Carefully cut off the cutting guide.

To use the rail fixture

1. Fold out the cutting guide.
2. Align the saw cut and fold in the cutting guide.
1631 - 001 - 04.05.2021
3. Move the product rearward and forward to decrease
the contact surface between the cutting blade and
the rail. More contact surface increases the risk of
glazing the cutting blade or making it blunt.
4. Cut the rail.
A
B
C
a) Cut through the section at the top (A).
b) Cut through the section in the middle (B).
c) Cut through the section in the bottom (C).
5. If the cut cannot be completed from 1 side, the
product must be turned around.
a) Stop the product. Refer to
page 26 .
b) Remove the product from the rail fixture.
c) Install the product with its left side to the rail
fixture.
To stop the product on
27