Cutting Blades; Applicable Cutting Blades; Assembly; Cutting Blade Vibration - Husqvarna K 1270 II Manual Del Usuario

Cutting blades

WARNING:
gloves when you assemble the product.
WARNING:
and cause injury to the operator.
WARNING:
for cracks, lost segments distortion or
unbalance prior to use and immediately after
striking an unintended object. Do not use a
damaged cutting blade. After inspecting and
installing the cutting blade, position yourself
and bystanders away from the plane of the
rotating cutting blade and run the power tool
at maximum no load speed for one minute.
WARNING:
manufacturer gives warnings and
recommendations for the operation and
correct maintenance of the cutting blade.
Those warnings are supplied with the cutting
blade. Read and obey the instructions that
are supplied with the cutting blade.

Applicable cutting blades

WARNING:
and abrasive blades for concrete and metal.
Do not use blades with serrations such as
circular wood cutting blades or blades with
carbide tips. The risk of kickback is
increased and carbide tips can come off and
be thrown at high speed. This can result in
injury or death.
WARNING:
for any other materials than what it was
intended to cut.
WARNING:
that comply with applicable national or
regional standards, for example EN12413,
EN13236 or ANSI B7.1.
WARNING:
with a rated speed value lower than that of
the product. The rated speed value of the
cutting blade is marked on the cutting blade,
1631 - 001 - 04.05.2021

Assembly

Always use protective
A cutting blade can break
Examine the cutting blade
The cutting blade
Only use diamond blades
Never use a cutting blade
Use only cutting blades
Do not use a cutting blade
and that of the product is marked on the
blade guard.
Note:
Many cutting blades that can be attached to this
product are made for stationary saws. The rated speed
value of those cutting blades is too low for this product.
CAUTION:
with thickness exceeding maximum
recommended thickness. Refer to
data on page 40 .
• Cutting blades applicable to this product are
available in two basic models; bonded abrasive
blades and diamond blades.
• Make sure that the cutting blade has the correct
center hole dimension for the installed arbor
bushing.

Cutting blade vibration

CAUTION:
too much force, the cutting blade can
become too hot, bend and cause vibrations.
Use the product with less force. If the
100 m/s
XXXX rpm
Do not use cutting blades
Technical
If you use the product with
13