Generator Activation; Generator Connections - Honeywell G0060341 Guia De Instalacion

5. After checking for leaks, check the gas pressure at the
regulator ports inside the generator to make sure there's
enough pressure for proper generator operation.
The local gas supplier is responsible for ensuring adequate
pressure, so if the pressure is too low, or if it's greater than
14 inches of water column, contact the gas supplier.
6. When finished checking the gas pressure, close the manual
shutoff valve.

GENERATOR ACTIVATION

When battery power is applied to the generator during the
installation process, the controller will light up. However, the
generator still needs to be activated before it will automatically run
in the event of a power outage.
Activating the generator is a simple one time process that is
guided by the controller screen prompts. Once the product is
activated, the controller screen will not prompt you again, even if
you disconnect the generator battery.
After obtaining your activation code, please complete the following
steps at the generator's control panel in the Activation Chart
(shown on the following page).

GENERATOR CONNECTIONS

1. Remove the two screws securing the connection area cover,
and remove the cover.
2. Feed the wires through the back of the generator and secure
the conduit with the lock nut.
3. Run the power leads through the strain relief provided.
4. The circuit breaker is attached to the exterior access panel.
5. Remove the plastic plugs inside the main breaker access area
to allow connection of the power leads to the circuit breaker.
6. Now connect the red and black power leads to the circuit
breaker. Since this is a single-phase application, it doesn't
matter which wire is connected to which lug.
7. Connect the green equipment ground wire to the ground bus
bar and torque to 35 inch lbs. The torque values are:
• 10-14 AWG = 35 in/lbs
• 8 AWG = 40 in/lbs
• 4-6 AWG = 45 in/lbs
General Information
7