the 3M clean-trace nG Luminometer will display the result. Press OK to accept and store the result. If the result is a fail, the user must acknowledge

this by pressing OK before further measures can be taken.

NOTE: If a measurement is attempted without a 3M clean-trace test in the chamber of the 3M clean-trace nG Luminometer, an error message

stating "no swab Detected" will be displayed and an audible beep will sound to notify the user that there is not a test in the chamber.

the result is now stored. the cursor will move to the next test point automatically, or use the navigation

buttons to highlight the next test

point required.

Pressing the back key will exit the testing.

5.03 Retesting

It is possible to retest a previously failed test point at any time after remedial action has been taken. select the correct test point as shown above and

measure.

Tabla de Contenido