Product-Dependent Symbols; Symbols On The Product; Product Information; Declaration Of Conformity - Hilti DD AF-CA H Manual De Instrucciones Original

These numbers refer to the corresponding illustrations found at the beginning of these operating
instructions
The numbering reflects the sequence of operations shown in the illustrations and may deviate
from the steps described in the text
Item reference numbers are used in the overview illustrations and refer to the numbers used in
the product overview section
This symbol is intended to draw special attention to certain points when handling the product.
1.3

Product-dependent symbols

1.3.1

Symbols on the product

The following symbols can be used on the product:
Alternating current
Protection class II (double insulated)
The product supports wireless data transfer.
If applied on the product, the product has been certified by this certification body for the US and
Canadian markets according to the applicable standards.
1.4

Product information

products are designed for professional users and only trained, authorized personnel are
permitted to operate, service and maintain the products. This personnel must be specifically informed about
the possible hazards. The product and its ancillary equipment can present hazards if used incorrectly by
untrained personnel or if used not in accordance with the intended use.
The type designation and serial number are printed on the rating plate.
▶ Write down the serial number in the table below. You will be required to state the product details when
contacting Hilti Service or your local Hilti organization to inquire about the product.
Product information
Auto-feed unit
Generation:
Serial no.:
1.5

Declaration of conformity

We declare, on our sole responsibility, that the product described here complies with the applicable directives
and standards. A copy of the declaration of conformity can be found at the end of this documentation.
The technical documentation is filed here:
Hilti Entwicklungsgesellschaft mbH | Tool Certification | Hiltistrasse 6 | D-86916 Kaufering, Germany
2 Safety
2.1 Safe operation of the auto-feed unit
WARNING
Non-compliance with safety instructions of the system products! The auto-feed unit is a system product
that is used only in combination with a diamond core drilling machine and a drill stand.
▶ Use the auto-feed unit only with compatible system products listed in the section headed "Intended use".
▶ Also study and follow all instructions relating to safety and operation in the corresponding operating
instructions of the system products (diamond core drilling machine, drill stand).
Study all safety instructions and other instructions, images and technical data with which this power
tool is provided. Failure to observe the instructions below or the instructions of the system products can
result in electric shock, fire and/or serious injury.
16 English
DD AF-CA H
01
2299964
*2299964*