Arīv MELD Manual Del Usuario página 20

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 101
shape of the charging socket is designed in such a way that the charging plug can only be inserted in the correct position. It may
take 2 to 3 hours depending on the charge level.
WARNING: Make sure the battery is properly installed & secured before each ride.
Sleep Mode
NOTICE: The battery may go into "deep sleep" mode if not used for more than 2 weeks.
If the battery is not used for more than 2 weeks or it is drained completely, it may go into a deep sleep. If your bike will not turn on
it needs to be awakened with the charger. Open the charge port cover and plug the charger into the battery. Plug the other end
into the power supply. Charger will flash green while it is charging and will turn off when charging is complete. Charger may take
some time to begin charging. Then push the on/off button. This should awaken the battery. Finish charging until the battery is fully
charged before use. Be sure to read the warning label on the side of the battery.
Cleaning
If you clean your battery only use a clean dry cloth.
WARNING: Do not use a pressure washer or hose to clean your bike. The battery is designed to be water tight to
rain water & road spray only.
Storage
If you do not use your bicycle for an extended period of time, you should remove it from the bike and store at room temperature.
Lithium ion batteries are best stored at a 40-60% charge level.
battery to 40-60% every 3 months. Do not leave the battery connected to the charger during long term storage.
Disposal
Used batteries must be collected separately and disposed of in an environmentally friendly manner. Please refer to your national,
state & local laws regarding disposal of batteries. If you need assistance please contact your ARĪV eBike ASP, local bike shop or
your local municipality.
Maintenance
None of the electrical components on your ARĪV eBike are serviceable except by your ARĪV eBike ASP. This includes the motor,
battery, charger, throttle, display unit and wiring harness. If you need to remove the battery, loosen the fastener with a 4mm hex
key and remove the battery from the carrier.
WARNING: Do not attempt to service or disassemble any of the electrical components on the ARĪV eBike
19
If you are storing your battery for a long period recharge your
EN
Tabla de contenido
loading

Este manual también es adecuado para:

MergeEb16-eu-bkEb16-eu-rdEb16f-eu-bkEb16f-eu-rd

Tabla de contenido