Disc Loading/Unloading - HHB CDR-850 Instrucciones De Operación

1
3
1 Function indicator
1 Indicateur de fonction
1 Indicador de función
1
2
Label surface
3
Emplacement
d'étiquette
Superficie de la
etiqueta
4
44
<PRE1282>
En
2, 4
1
POWER
OFF ON
OPEN/
CLOSE
OPEN/
CLOSE

DISC LOADING/UNLOADING

Loading/unloading a disc
1
Press the POWER switch to turn the power ON.
÷ The function indicator blinks green.
÷ The display panel is illuminated.
2
Press the OPEN/CLOSE 0 button to open the
disc tray.
"OPEN" is displayed and the tray comes out.
÷ After recording or skip information recording, it takes a few
seconds before the disc tray can open because the recording
information is being written on the disc. "OPEN" blinks
during this period.
3
Place a disc in the disc tray
÷ Place the disc in the center of the tray with the label side up.
÷ When using an 8 cm (3 inch) disc make sure the disk is
located in the groove in the middle of the CD tray.
÷ Ensure only one disc is loaded at a time
÷ The disc must be loaded label side up. ( Please note this
differs from the CDR-800 where the disc is loaded with the
label side down.)
4
Press the OPEN/CLOSE 0 button to close the
disc tray.
"CLOSE" is displayed and the tray is closed.
The disc tray can also be closed by
÷ pressing the 3 button.
÷ pushing the disc tray lightly.
÷ When a disc is loaded, the disc type is identified and the
information on the disc is read. (During this time, "CD?",
"CD-R?" and "CD-RW?" are displayed alternately.)
A
Display for a non-recorded CD-R disc:
B
Display for a non-recorded CD-RW disc:
C
Display for a partially recorded CD-R disc:
D
Display for a partially recorded CD-RW disc:
E
Display for a prerecorded CD or finalized CD-R disc:
The total playing time is displayed.
F
Display for a prerecorded and finalized CD-RW disc:
The total playing time is displayed.
G
An attempt is made to start playback without loading a
disc: