HHB CDR-850 Instrucciones De Operación página 42

A
1
TIME/
MARGIN
4
B
1
TIME/
MARGIN
5
42
<PRE1282>
En
2
TIME
3
2
TIME
3
4
DISPLAY PANEL
Switching the time display
The following operation allows you to check the recording
time information during recording or playing time information
during playback.
Press the TIME/MARGIN button (or the TIME button on the
remote control unit) repeatedly to switch the time display.
Information that is displayed during playback and recording
operation modes slightly differ. The time information and the
order it is displayed in for both modes is shown below.
A
During recording
1 : Elapsed recording time
(2 min. 16 sec. after the start of track 2)
2 : Remaining recording time
(56 min. 10 sec. remaining on the disc)
3 : Total recording time
(3 min. 50 sec. of 2-track recording)
4 : Margin indicator
(Left channel: 5dB, Right channel:3dB)
B
During playback
1 : Elapsed playing time
(2 min. 16 sec. after the start of track 2)
2 : Remaining playing time of track being played (3 min. 20
sec. remaining for track 2)
3 : Remaining playing time of all tracks on disc being
played (46 min. 40 sec. remaining on the disc)
4 : Total playing time
(60 min. 0 sec. for 8 tracks)
5 : Margin indicator
(Left channel: 5dB, Right channel:3dB)
c
During stop.
1 : Remaining time on disc
2 : Total recorded tracks and total recorded time
To read the margin indicator.
The margin indicator displays the difference between the
peak input level and the maximum recordable level (0dBfs),
for both the right and left channels. The margin indicator
should be used when setting the record level from an analog
source, or checking the peak level when playing back a disc.
If the maximum peak level is exceeded "00" blinks for the
respective channel (distortion of the signal may occur).
To reset the margin indicator
Press the SKIP ID CLEAR button while the margin indicator is
displayed.