Tabla de contenido
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
1.
If the vacuum will not operate, check the following:
a. The battery pack connection to the vacuum.
b. The battery pack is charged.
c. That the switch is in the "on" position and functioning properly.
2.
If the battery pack is not charging check that the charger is plugged into 120 Volt out-
let and the connection with the charger is seated to the battery pack correctly.
3.
If the exhaust that comes out of the bottom of the vacuum is warmer than usual,
check, clean or replace all four filters.
4.
If loss of suction occurs, check the following:
a. Check that debris is not plugging the hose, wand, and/or floor tool.
b. Check, clean or replace both Intercept Micro and Micro Cloth filters.
c. Check that the hose cuffs are fitting tightly on the hose and are not cracked.
d. Check that the cap is properly attached to the vacuum body.
5.
If the charger's LED indicator is off and no output voltage when plugged in, check the
AC power source.
6.
If the charger's LED indicator is off when charging, check the output cable.
PROPER VACUUMING MOTION FOR LARGE AREAS
1.
Begin with the wand parallel to your body.
2.
Draw the top of the wand in toward your waist and twist at
the waist walking backward or forward (a side-to-side motion)
(Figure CC).
3.
The motion is similar to mopping and keeps the upper body and
arms from tiring.
BACKPACK ERGONOMICS
n
The weight of the vacuum should be carried on the operator's
hips and be evenly distributed. The padded waist belt and shoul-
der straps are adjustable for a custom fit.
The on/off switch is conveniently placed for easy access on the
n
waist belt of the backpack vacuums.
Use the proper attachments for the job. ProTeam has attachments to perform most jobs
n
without requiring that the operator bend over or get into difficult positions.
6
O P E R A T I O N
Figure CC
Capítulos
Tabla de contenido
