Night Blinds (Alba - Optional); Glass Doors - Arneg Alba Guía De Instalación Y Manejo

Alba-Bucarest
English
The light switch is located on the aluminium ceiling light Fig. 23.
ATTENTION! Accidental breakage of bulbs. Injury. Contamination of the goods.
- wear PPE
- cut off power supply to the cabinet
- remove all goods
- clean the cabinet as indicated in section 21.4
- remove any trace of glass from the goods
- replace the bulbs with identical ones
- reload the cabinet with goods cleaned thoroughly
- restore electrical power supply.

19. Night blinds (Alba - optional)

DANGER! Live parts. Electrocution.
REMOVE THE ELECTRIC POWER SUPPLY BEFORE ANY OPERATION!
To avoid low-temperature variations and ensure the hygiene of the goods over night, the cabinet can
be equipped with manual/automated blinds.
Keep a clearance of 10 mm between the lower end of the blind and the suction plate.
DO NOT exceed this limit
DO NOT place the end on the suction plate
Installation
procedure
manual blinds
(Fig.27)
Spring units load
Manual blinds width (mm)
indicative chart
Recommended preload with sheet rolled up (no. of windings)
Spring max load with the sheet rolled completely (no. of wind-
ings)
Installation pro-
cedure
motorised blind
(Fig.28)

20. Glass doors

Operation
• the door closes by itself for angles of less than 60°
• for angles greater than 60° the door locks to facilitate loading and cleaning
Fig.22
• to close, simply accompany the door in closing
i
It is the Customer's responsibility to inform consumers with suitable means of communica-
tion about correct use of the doors.
44
Step
1 Fix the blind supports A
2 Insert the flat pin in the blind A support
insert the fastening element B on the blind
3
insert B + blind in support A
4 turn B clockwise B until it clicks
to lock the blind each time you turn it: turn the flat pin so that the word
"UP" is facing upwards
a different position would release the automatic lock
Step
1 insert stopper F, turn it and lock it in housing D
2 insert the blind using pin G
3 insert the opposite stopper, repeat step 1
operations
See chap.4.5
Action
Action
<1250 >1250
20-30 25-30
50 55
05060188 00 10-02-2020