Installation Of Components; Usb Cable - Sirona Dental USB-Box Instrucciones De Uso E Instalación

4 installation
4.3

Installation of components

1.
18
2.
3.
A
Installation alternatives
The device does not need to be fastened in any particu-
lar way.
Stationary fastening is possible. This is done by mount-
ing the aluminum rail on top of or underneath the table
using screws.
Screw the aluminum rail of the USB – Box onto the loca-
tion where you would like to install the USB – Box later
on.
1. Press inward latch A located at the bottom and push
the X-ray box housing out of the aluminum rail.
2. Fasten the aluminum rail in the desired location us-
ing two screws.
3. Push the X-ray box housing back onto the aluminum
rail until it locks in place.

USB cable

Connect the USB cable between the USB – Box and the
PC.
ATTENTION
To ensure functional reliability, connect only the USB –
Box to the USB interface of the PC. This connection must
not be shared by other USB components. The USB –
Box must not be connected via a USB hub.
Sirona Dental Systems GmbH
59 15 702 D 3334
D 3334.201.02.13.02