Long Workpiece Support; Additional Workpiece Support - Bosch CM12SD Instrucciones De Funcionamiento

BM 1609B04985 11-14_CM12SD 11/12/14 2:52 PM Page 26

long Workpiece Support

WARNING
and properly supported from underneath.
WARNING
as additional support. Unstable support for the
workpiece can cause the blade to bind or the workpiece
to shift during the cutting operation, causing you to
contact the spinning blade.
Operating Sliding Base Extensions – These
extensions provide extra work piece support and are
especially useful when cutting long work pieces. To
reposition the extensions, simply turn the red knobs
located on the base next to the extensions in a counter-
clock position. To tighten extensions turn the red knobs
in a clock position (see figure 31).

Additional Workpiece Support

Blocks – Long pieces need extra support. The base
height is 4-1/2 inches. Cut two 2x4 pieces to 4-1/2" in
length and fasten together. Boards of this thickness and
height can be used to create auxiliary support
extensions for long workpieces, figure 32.
WARNING
the workpiece and allow for secure holding by hand
outside of the "No Hand Zone", or clamping with a clamp
inside or outside of the "No Hand Zone" – see page 23
for "No Hand Zone" and appropriate hand positions.
WARNING
Unsupported workpiece can move out of position during
cut and cause injury and/or tool damage.
WARNING
Off by conducting a simulated cutting cycle, and
observe the projected path of the saw blade. Keep
hands at least six (6) inches away from the projected
path of the saw blade.
preparing for Saw Operations
Workpiece Support
long workpieces have a tendency
to tip over unless clamped down
Do not use another person as a
substitute for a table extension or
Always ensure that supporting
surfaces are able to properly support
Always adjust the sliding base
extension to support workpiece.
Be aware of the path of the saw
blade. Make a dry run with the saw
FIG. 31
Base Extension
Clamping Knob
FIG. 32
2x4 Pieces
26.
Two
4-1/2"