Adjustments; Using The Head Assembly Lock Pin - Bosch CM12SD Instrucciones De Funcionamiento

BM 1609B04985 11-14_CM12SD 11/12/14 2:52 PM Page 14
WARNING
source before
adjustments or repairs.
Head Assembly lock pin
The head assembly lock pin (figure 7) is used to hold
the saw's head assembly in the DOWN position. This
position prevents the head from bouncing up and
down during transportation. This also makes the saw
more compact for lifting and storage. This position is
also required for some calibrating procedures.
To Engage the Head Assembly lock pin:
1. Check that the depth stop plate is disengaged,
swing to the back, (figure 8).
2. Grasp the saw's main handle and press down on
the head assembly.
3. While pressing the saw head down, push in on the
head assembly lock pin, (figure 7). Release the
head assembly. The head will be locked in the
DOWN position.
To Disengage the Head Assembly lock pin:
1. Grasp the main handle and press down on the
head assembly.
2. While pressing the head down, pull out the head
assembly lock pin. Release the lock pin, but
maintain your grip on the main handle. Slowly
allow the spring-loaded saw head to come up to
the top of its travel and then release the handle.

Adjustments

Using the Head Assembly lock pin

To avoid possible
disconnect plug from power
performing any assembly,
injury,
FIG. 7
Head
Assembly
lock pin
14.
FIG. 8
Depth
Stop plate