Assembly; Unpacking And Checking Contents; Tools Needed For Assembly And Alignment - Bosch CM12SD Instrucciones De Funcionamiento

BM 1609B04985 11-14_CM12SD 11/12/14 2:52 PM Page 10
Unpacking the Miter Saw – When removing this tool
from packaging materials, reach down to the two side
carry-handle locations and slowly lift until it clears the
package.
WARNING
any component of the mechanism support
system.
Loose Parts - 1 of each shown
Manual

Tools Needed for Assembly and Alignment

Assembly

Unpacking and Checking Contents

To avoid severe pinching, never
lift or move this saw by gripping
Workpiece Clamp
Combination Square
4/6mm Hex Key
Checking Contents in package – Open the top of
the package and look for the included loose parts.
Refer to the diagram below.
To avoid possible injury, always
WARNING
disconnect plug from power
source before
adjustments or repairs.
Check off for each part
#2 Phillips Screwdriver
(supplied)
10.
performing any assembly,
Dust Bag
4/6mm Hex Key