Key - View Log - Bentel Security FC500 Manual Del Usuario

8 KEY - View Log

Use the 8 Key to select view LOG (see Figure 54) or
directly from the STANDBY status (see Figure 38).
The option View Log of the menu View parameters
will allow you to view the stored events in the Log of the
fire control panel.
This Control panel can stored the last 4000 happened
events.
When the Log is full, the oldest event will be deleted, so
the newest will be stored.
+
Use the option DELETE LOG of the Modify menu
to delete the Log events.
The following data will be stored in the LOG:
Ø Event description
Ø Event number
Ø Description of the device (Master panel, Slave panel
or Repeater) that generated the event
Ø Description of the item that generated the event
Ø Time and date of the event
Ø Address of the Item which generated the event.
In this phase:
Alphanumeric keypad Used to activate the display fil-
ters.
New code: 1: Alarm events only, 2: Pre-alarm events
only, 3: Warning events only, 4: Test events only, 5:
Fault events only, 6: Restore events only, 7: General
events only.
Cursor Keys Use the UP Key to select the previous
avaible event;
Use the Down Key to select the next avaible event;
Use the Right Key to view the next avaible data;
Use the Left Key to view the previous avaible data.
ESC Key Use ESC key to cancel the operation and to
step back to main page.
ENTER key No function is related to ENTER key.
Function Keys No function is related to F1 key;
No function is related to F2 key;
Total stored Events
Total :0297
Event :0292
At present
stored events
Figure 55 DISPLAY: View LOG
If present, it shows the filtered
view by type of events
*
MS:Loop 2 det191
08:43:11 - 01/01/07
Time and date
conncted to
the event
VIEW-LOG-PARAMETERS
Total :0297
Event :0292
MS:Loop 2
Total :0297
Event :0292
Total :0297
Event :0292
Figure 54 View LOG: roll by DX key
No function is related to F3 key;
If the displayed event originates from a different control
panel, pressing the F4 key will enable navigation within
the Event Log (LOG) for that control panel.
+
If the events are linked to the devices, the zone la-
bel alternates with the point label every 5 seconds.
If the zone has not been associated with the point,
only the point label will appear.
+
If the displayed events are filtered by type, "*" will
immediately begin to blink to the right of the event
number.
This symbol shows the presence
Control panel status of the connection between the
User Interface and the Main Board
status: VIEW LOG
RESTORE
zone=002
This symbol: shows the presence of
following blocks which roll by DX key
( which came before by SX key)
status: VIEW LOG
RESTORE
det191 zone=002
08:43:11 - 01/01/07
Push the right key to scroll
the second block of data
regarding the zones in the LOG
status: VIEW LOG
RESTORE
Zone: Reception
08:43:11 - 01/01/07
Push the right key to scroll
regarding the causes in the LOG
status: VIEW LOG
RESTORE
Cause:8011H NO DATA
08:43:11 - 01/01/07
Events
Type
1° block
the third block of data
47