Error Messages - Mondolfo Ferro MT 3800 LASER Manual De Uso

- the internal sensor was not in the rest position.
Position it to the rest position and repeat the
procedure.
Select the Exit
programme without performing a calibration.
Service
This program displays some data that are used
to test machine operation and to detect the
malfunctioning of some devices. Since these
data are not useful for the operator, it is recom-
mended that only technical support technicians
consult them.
Select the service programmes icon to display
this programme
Monitor Auto Setting
This program is used to optimise the synchro-
nisation of the LCD motor approved by the
manufacturer. Proceed as follows to perform
this synchronisation:
- select the
TING icon;
- once selected, the following screen will ap-
pear on the monitor
- to perform the synchronisation, press the cor-
responding key directly on the LCD monitor (read
the instructions in the monitor user manual).
78
icon to exit the
.
MONITOR AUTO SET-
Push the
gram without performing the synchronisation.
IMPORTANT:
repeat the operation if necessary if the syn-
chronisation was not successful.

ERROR MESSAGES

The machine can recognise a certain number
of malfunction conditions and signals them by
displaying the relevant messages.
– A – Notice messages
A 3
Wheel not suitable for performing the sensitivity
calibration, use a wheel of average dimensions
(typically 5.5"X14") or larger but with a weight
that does not exceed 40 kg.
A 5
Incorrect wheel data for an ALU programme.
Correct the set dimensions.
A 7
The machine is temporarily not enabled to select
the programme requested.
Perform a wheel spin, then repeat the request.
A 20
Ultrasonic sensor calibration template in an in-
correct position during calibration. Bring it to the
position indicated and repeat the calibration.
A 23
Data entry incomplete or incorrect in EASY ALU.
Enter again correctly.
A 25
Programme not available on this model.
A 26
Programme available only after selecting one of
the following programmes: EASY ALU 1 / EASY
ALU 2 / Motorcycle Dynamic / Motorcycle Alu.
A 31
Optimisation procedure (OPT) already launched
by another user.
A 51
Incorrect wheel clamping (only with the auto-
matic wheel clamping system).
Repeat the locking operation.
A 52
hub mounting/demounting procedure started
automatic wheel clamping system.
After 30 seconds, the procedure ends auto-
matically.
MT 3800 LASER - Operator's manual
exit key to exit the pro-