Mondolfo Ferro MT 3800 LASER Manual De Uso página 49

- connect the signal cable and the power supply
cable to the rear monitor panel (B,C fig.6).
Wheel guard and related support
mounting procedure
- Mount the bush (A, fig. 7) on the rotation pin
(B, fig. 7). While doing this, make sure that
the groove on the pin is aligned with the plug
in the bush.
B A
- Block the bush on the pin using the M12 screw
supplied with the machine.
- Insert the metal tube (D, fig. 8) into the two
plastic guard front holes (C, fig. 8).
- Couple the guard to the rear side of the tube
by inserting it into the correct position with
snap-on coupling (E, fig. 8).
- Lock the guard by tightening the screw F
(fig. 8).
MT 3800 LASER - Operator's manual
6
Assembly of the ultrasonic sensor
and its "optional accessory
supplied on request" support for
automatic width measurement
- insert the ultrasonic sensor cable inside the
slots in the metal pipe (see fig.9) fixing the
cable using the supplied hose clamp (A, fig.9)
7
- fix the ultrasonic sensor support to the guard
pipe using the supplied screws (Fig.9a);
E
F
C
8
D
9
UK
49