Configuration Programs; Selection Of Adhesive Weights Application Position - Mondolfo Ferro MT 3800 LASER Manual De Uso

ate the manual data setting.
After setting the dimensions manually, the
required balancing programme can be selected
as follows:
- select the balancing programme icon
- press the Kis knob or the ENTER button.
Each time the Kis is pressed, the machine
automatically changes the type of balancing
programme (as shown on the graphic on the
video) in the following sequence:
Dynamic
ALU1
ALU2
ALU3
ALU4
ALU5
Motorcycle dynamic
Motorcycle ALU
STATIC

CONFIGURATION PROGRAMS

The Configuration programmes are those func-
tions that are intended for customising the
machine's operation and are normally executed
when the machine is installed.
The list of the configuration programmes can
be displayed as follows:
Select the utility and configuration pro-
-
grammes icon
Select the configuration programmes icon
-
.
Automatic Position Search (RPA)
Configuration
Enables/disables the automatic positioning of
the wheel at the end of the spin. After the list
of the setting programmes is displayed, proceed
as follows:
Select the Automatic position search
-
MT 3800 LASER - Operator's manual
.
configuration icon
The following icons are displayed:
RPA OFF; disables the automatic position search
procedure.
RPA ON; enables the automatic position search
procedure.
- Press the the Kis knob or ENTER button
to select the icon desired.
- Press the
the setting and exit.
The selection can also be seen in the working
screen status line.
Selection of adhesive weights
application position
To access this programme you must:
- select the Utility programmes icon,
- select the configuration programmes icon
- Three icons will appear on the display that
represent the possible positions, as shown
below:
H12: the balancing weight must always be
applied in the 12 o'clock position regardless
of the type of balancing programme selected
or the type of weight to be applied (adhesive
or spring);
LASER: the balancing adhesive weight must be
applied in correspondence of the laser line
(in all balancing programmes) whereas the
clip weight must always be applied in the 12
o'clock position;
CLIP: the balancing adhesive weight must be ap-
plied using the weight holder in ALU1 and ALU2
programmes, whereas the spring weight must
always be applied in the 12 o'clock position.
- Use the Kis knob or the arrow buttons to se-
lect the desired position. The selected icon is
.
Exit button to save
73
UK