Mondolfo Ferro MT 3800 LASER Manual De Uso página 76

LASER activation/deactivation
It is possible to activate or deactivate the laser
when present on the machine.
After the list of the setting programmes is
displayed:
- Select the LASER activation/deactivation icon
- Two icons will appear on the display that
represent the possible LASER modes, as shown
below:
LASER OFF.
LASER ON. In this configuration, the laser
turns on in the following cases:
for the manual application of all adhesive
weights.
IMPORTANT:
If the operator selected the adhesive weight
application configuration using a CLIP, in the
Alu1 or Alu2 balancing programmes the laser
will not be activated as the weight will be
applied using the weight holder
In the Hidden Weight programme, the selection
of the two new positions behind the spokes is
done in the 6 o'clock position using the laser
line.
Press the Kis knob or the ENTER button
to select the desired mode
The selected icon is enabled if it is in the fol-
lowing configuration:
- press
made and exit the function.
Sensitivity Calibration
Calibrate when detecting that the setting con-
dition is out of tolerance or when the machine
so requires as the E 1 message is displayed.
Calibrate as follows:
1. Select the sensitivity calibration icon
. in the configuration program menu
76
to confirm the selection
.
2. Fit a wheel of average or larger dimensions
preferably with only small unbalance on the
wheel balancer;
3. activate spinning;
4. At the end of the spin, fix the calibration
weight supplied with the machine on the
swinging unit bell as indicated in figure 27;
5. spin again;
6. At the end of the spin, change the position
of the calibration weight on the swinging
unit bell as indicated in figure 28;
7. spin a third time;
At the end of the fourth calibration spin,
MT 3800 LASER - Operator's manual
27
28