Mondolfo Ferro MT 3800 LASER Manual De Uso página 72

Visual inspection function
This function allows the wheel to be run at low
speed and with the guard open, This allows visual
checking for any geometrical irregularities in
the rim and wheel.
Follow the description detailed below to start
the procedure:
- keep the button
the guard open for as long as necessary for
wheel inspection.
When the button is released, the wheel-holder
shaft locking device activates automatically.
Highest accuracy function
This function allows the operator to check the
balancing results on the screen with the best
possible accuracy ("Gr x1" or "Oz 1/10").
Select the highest accuracy icon
-
.
- Keep thethe Kis knob or Enter button
pressed as long as desired.
Spin Counter Function
To access this programme you must:
• Select the icon Utility programmes.
• Select the icon Configuration programmes.
• And select the icon Spin counters.
The screen which appears has 3 counters:
• The first shows the number of spins performed
during the entire working life of the machine.
• The second shows the number of spins per-
formed since the last machine reset.
• The third shows the number of spins performed
since the last sensitivity calibration.
To quit the programme, press the Exit
button.
Manual wheel data entry function
If the automatic measuring arm fails to operate,
the geometric data can be entered manually
by following the procedure below:
72
-
-
pressed with
-
-
-
-
-
-
-
-
Select the manual wheel data entry icon
.
The data screen showing the icons is dis-
played:
manual wheel data change;
unit of measurement (inch/mm)
change;
displays the help information regarding
the current screen.
Select the dimension change icon
.
The wheel balancer prepares for manual
entry of the width.
Change the displayed value with the value
measured with the manual caliper using the
keypad.
Press the the Kis knob or ENTER button
to confirm and switch to the
diameter value entry phase.
Change the value of the diameter displayed
by entering that indicated on the tyre using
the keypad.
Press the the Kis knob or ENTER button
to confirm and switch to the
distance value entry phase.
Using the keypad, modify the value meas-
ured with the tape measure between the
body and the inner side of the rim.
Press the Exit
MT 3800 LASER - Operator's manual
button to termin-