Mondolfo Ferro MT 3800 LASER Manual De Uso página 57

- Keep the arm in contact with the rim until the
machine has acquired the wheel's diameter
and distance values. The following screen
appears during this phase:
- if only one measurement is taken, the machine
interprets the presence of a rim with balancing
using a clip weight on both sides (Dynamic
Balancing Programme)
- moving the arm to the rest position, the ma-
chine will set up for the manual WIDTH entry.
- in this phase, it is possible to perform an ad-
ditional acquisition of the rim diameter and
distance.
- Measure the width of the rim using the caliper
provided (fig. 15).
MT 3800 LASER - Operator's manual
- Change the displayed width value by increasing
or decreasing the value using the keypad or
turning the kis.
After updating the wheel data the user can:
1) Press the Exit
the unbalance values recalculated according
to the new dimensions.
2) Press pressing the Kis knob or the Enter
button
dimension programme to convert and/or
change the wheel data.
- if two subsequent measurements are taken
inside the rim on two balancing planes, the
machine interprets the presence of a rim with
balancing using a clip weight on the inner plane
and an adhesive weight on the external one
(Easy ALU 2).
EASY ALU 2
15
button to display
to access the Manual
57
UK