Derungs Dmed Triango 100 C Instrucciones De Montaje Y Funcionamiento página 24

ENG
3.5 Installing the ceiling arm
WARNING
The opening spring balanced arm is an injury hazard

Do not remove the transport safeguard until after the
luminaire head has been mounted

Connect the plug from the ceiling tube with plug on the
ceiling arm

Carefully push protruding cable into the ceiling tube
Perform this assembly step on an even surface:
3

Insert the sliding piece 1 above into the ceiling arm
groove 2

Push the ceiling tube 3 and ceiling arm 2 together

Secure the sliding piece 1 by screwing in the threaded
stud 4 (up to the stop)

Loosen the threaded stud 4 again by a maximum of a ¼
turn and checking the rotating function.

Continue with luminaire head assembly, see Chap. 6
4. INSTALLATION: Triango 100 W
4.1 Workload data
Bending moment M
B
Vertical weight F
G
24
1
4
2
275 Nm
155 N
4.2. Installing the wall holder
►
Fastening hardware does not come with delivery.
DANGER
Assembly by qualified personnel
►
Assembly must be done by qualified personnel only.
Lack of appropriate knowledge may pose a death
hazard.
►
Two people are needed for assembly.
CAUTION
Determine the fasteners to use from the workload data
table
►
Before assembly, make sure the rod dimensions are
correct.
CAUTION
Make sure the wall holder is in the correct position.
►
The wall holder must be aligned according to the axis
in the image.
►
Misalignment will compromise mechanical safety.
►
We recommend using a counterplate on lightweight
construction walls (not included with delivery).
DANGER
Death hazard from electric shock.
►
All poles of the luminaire must be disconnected from
the power supply by an external lockable switch.
►
Draw 6 drill marks.
Observe the position of opening "A" for connecting
►
the current.
WARNING
Wear safety equipment according to the tool manufacturer's
instructions.
A