Idiomas disponibles
Idiomas disponibles
5.2.1 Without adapter
Press the quick-release lever
22
Place the quick-release lever
Press the trigger
.
21
Read the built-up air pressure on the pressure gauge
Release the trigger
.
21
Push the quick-release lever
22
5.2.2 With valve adapter, ball needle, universal adapter
Press the quick-release lever
22
Insert the valve adapter
24
lease it.
Now press the valve adapter
Press the trigger
.
21
Read the built-up air pressure on the pressure gauge
Release the trigger
.
21
Push the quick-release lever
22
25
down to put it on.
on the valve and then release it.
22
.
18
down and pull it off the valve.
22
down to put it on.
into the quick-release lever
and then re-
22
onto the valve.
24
.
18
down and pull it off the valve.
24
22
22
26
22
5.2.3 With extension nozzle
The extension nozzle
is for cleaning/blowing cavities or hard-to-reach
27
places, as well as for cleaning dirty implements. The continuously adjustable
trigger
allows the compressed air to be metered.
21
Screw the extension nozzle
directly into the pneumatic tyre inflation gauge.
27
You do not need the hose with quick-release lever
27
6. Cleaning, maintenance, transport and storage
by the user
Clean and maintain your compressor carefully and regularly. This is the only
way to ensure flawless operation and a long service life.
Regardless of the number of operations or actuations, maintain and clean the
device after each use.
6.1 Safety measures
Be sure to observe the following instructions during maintenance and
cleaning work:
Switch off the compressor by pressing the on-off switch 8 to the "0"
position.
Disconnect the compressor from the power supply by pulling the mains
plug. Thus, the compressor is separated from the energy supply.
Relieve the pressure from the compressor to avoid material damage. For
example, you can connect an air blow gun to the compressor and use it to
empty the pressure vessel 3 .
Attention should be paid to the disposal instructions given in this manual.
Improper disposal may harm the environment or your health.
Clean the device of hazardous substances deposited on it (due to work
processes) before servicing. Avoid any skin contact with these substances.
If skin comes into contact with hazardous dusts, this can lead to severe
dermatitis. If dust is generated or stirred up during maintenance work, it
can be inhaled.
Always wear protective gloves and a protective mask!
The device must only be operated and maintained by trained persons.
Repairs may only be carried out by qualified persons.
If possible, inspections, adjustments and maintenance work should be carried
out by the same person or their deputy and documented in a maintenance log.
for this application.
23
GB/IE/NI/CY/MT
13
