Idiomas disponibles
Idiomas disponibles
2.6 Residual risks
Even if you operate this machine according to the instructions, there are always residual risks. The following hazards may occur in connection with the design
and construction of this machine:
a) Lung damage if suitable respiratory protection is not worn.
b) Hearing damage if suitable ear protection is not worn.
c) Damage to health resulting from vibration emissions if the device is used for a long period of time or is not properly managed and maintained.
WARNING!
This machine generates an electromagnetic field during operation. This field may affect active or passive medical implants under certain circumstances. To
reduce the risk of serious or fatal injury, we recommend that persons with medical implants consult their physician and the medical implant manufacturer
before operating the machine.
3. Compressor operation
3.1 Before first use
Remove all packing material and transport locks from the device. Check that
the package contents are complete and undamaged. If possible, keep the
packaging until the warranty period has expired.
3.1.1 Mounting the feet
12
6
16
Mount the foot
with the hexagon head screw
6
as shown in the illustration.
Repeat these steps to mount the second foot
An open-ended spanner is not included in the scope of delivery.
3.1.2 Mounting the wheels
12
13
Fit the wheel bolt
into the washer
15
.
4
Tighten the nut
onto the wheel bolt
13
can still be turned on the screw.
Pass the wheel bolt
through the hole on the wheel linkage.
15
Fasten the wheel
with the flange nut
4
Repeat these steps to mount the second wheel
An open-end spanner is not included in the scope of delivery.
12
6
16
and the flange nut
16
.
6
4
14
15
then through the hole in the wheel
14
. Make sure that the wheel
15
.
12
.
4
3.1.3 Setting up the device
For safe and correct operation of the device, the installation site must meet the
following requirements:
The floor must be firm, flat and level. Do not place the device in a hot, wet
or very humid environment or near combustible material.
The socket must be easily accessible so that the mains plug can be easily
disconnected if necessary. The use of a cable extension is not recommend-
ed. Long supply cables can cause a voltage drop and thus prevent the
motor from starting.
If you still have to use a cable extension, make sure that it is not longer than
5 m and that the cross-section is at least 1.5 mm². ALWAYS use the cable
extension rolled out!
3.2 First use
READ THE MANUAL OF THE PNEUMATIC TOOL BEFORE CONNECTING
IT TO THE COMPRESSOR!
Make sure the on/off switch
sor to an earthed socket protected by a residual current circuit
12
breaker.
3.2.1 Switching on/off
Press the on/off switch
switched on.
To switch off the compressor, press the on/off switch
position.
3.2.2 Air pressure presets
The following pressures are preset:
- Switch-on pressure: approx. 8 bar
- Cut-off pressure: approx. 10 bar
4
3.2.3 Setting the air pressure
The pressure gauge
11
With the pressure regulator
Pay attention to the nameplate of the pneumatic tool to be connected!
is "0". Now connect the compres-
8
to the "I" position. The compressor is
8
shows the current pressure in the pressure vessel 3 .
you can set the desired pressure (0 -10 bar).
10
GB/IE/NI/CY/MT
to the "0"
8
11
