Idiomas disponibles
Idiomas disponibles
You can read off the actual pressure delivered on the right-hand pressure
gauge 9 . This is delivered at the two quick couplings 2 .
3.2.4 Safety valve
NOTE
Repeat this process every 30 operating hours or at least three times a year.
3.2.5 Draining condensation
Condensation collects at the bottom of the tank 3 .
Open the drain plug 5 on the underside of the tank completely .
Tilt the compressor to the side so that the drain plug 5 is at the lowest
point of the tank 3 and wait until condensation has drained completely.
Then close the drain plug 5 again.
CAUTION
Condensation must only be drained when the tank 3 is NOT under pressure.
NOTE
Drain condensation after each operation, but at least once a week.
3.2.6 Releasing overpressure (adjusting pressure)
Switch off the compressor.
Use the overpressure with an idle pneumatic tool.
12
GB/IE/NI/CY/MT
WARNING!
The safety valve 7 is set to the
maximum permissible pressure of
the pressure vessel 3 . It is not per-
mitted to adjust the safety valve 7
or remove the connection lock be-
tween the drain nut and its cap.
Turn the drain nut counterclockwise
to open the safety valve 7 outlet.
The safety valve 7 now audibly re-
leases air. Then retighten the drain
nut clockwise.
5
4. Operating the pneumatic hose
Pay attention to the maximum working pressure of the hose
the hose
only within the specified parameters (see technical data).
17
Press the pneumatic hose
17
pneumatic hose
locks into place.
17
Connect the pneumatic tool via the quick coupling of the pneumatic
hose
.
17
After work, remove the tool from the pneumatic hose
quick coupling firmly backwards. Hold the pneumatic hose
the hose swinging around cannot injure anyone.
5. Operating the pneumatic tyre inflation gauge
5.1 Before first use
The product may only be operated with cleaned, condensate-free and oil-free
compressed air. The maximum working pressure of 8 bar on the product must
not be exceeded.
Connect the product to the compressor by connecting the quick coupling of
the pneumatic hose
to the connector plug
17
regulate the air pressure with the integrated pressure regulator
5.2 First use
The pneumatic tyre inflation gauge makes inflation easy. The pressure gauge
is used to check the pressure. With the integrated drain valve
lower pressure that is too high.
17
into one of the two quick couplings 2 . The
, by pulling the
17
firmly so that
17
. The lock is automatic. You
20
.
10
it is possible to
19
. Operate
18
