KitchenAid 720-0787 Instrucciones De Instalación Y Manual De Uso Y Cuidado página 23
Asador autonomo para exteriores
Ocultar thumbs
Ver también para 720-0787:
Idiomas disponibles
Idiomas disponibles
Prepare
the Grill for Lighting
1. Open the hood completely.
Do not light burners with the hood
closed.
2. Make sure control knobs are turned to OFF. The grease cup
must be in place.
4. You will hear the "snapping"
sound of the spark. When burner
is lit, release the knob. Turn knob to desired setting.
5. Repeat for each of the other burners as needed.
IMPORTANT:
If burner does not light immediately, turn the
burner knob to OFF and wait 5 minutes before relighting.
Manually
Lighting
Main Burners
1. Open the hood completely.
Do not light burners with hood
closed.
2. Do not lean over the grill.
3. Remove the manual lighting extension (see following
illustration) and attach a match to the split ring.
A. Grease
cup
Turn the Gas Supply
On
1. For using a 20 Ib LP gas fuel tank: Slowly open the tank valve.
NOTE: If flow limiting device activates, your grill may not light. If
your grill does light, the flames will be low and will not heat
properly. Turn tank valve and all control knobs off and wait 30
seconds. After shutting off the tank, very slowly open tank valve
and wait 5 seconds before lighting.
2. For outdoor grills using gas supply source other than a 20 Ib
LP gas fuel tank:
Open the manual shutoff valve in the gas supply line. The valve
is open when the handle is parallel to the gas pipe.
4. Strike the match to light it.
5. Guide the lit match between the grill grate.
6. Push in and turn the burner knob to IGNITE/HIGH for the
burner closest to the lit match. The burner will light immediately.
When burner is lit, turn knob to desired setting.
A. Ct_d
_e
Lighting
the Main Burner
1. Open the hood completely.
Do not light burners with the hood
closed.
2. Do not lean over the grill.
3. Select the burner you want to light. Push in and turn the grill
burner control knob to IGNITE/HIGH, while continuing
to hold it in.
7. Repeat steps 2 trough 6 for each main burner.
8. Remove match and replace manual lighting extension
inside
the cabinet door.
IMPORTANT:
If burner does not light immediately, turn the burner knob to OFF
and wait 5 minutes before relighting.
If any burners do not light after attempting to light them manually,
contact the Customer Service Center. See the " Assistance or
Service" section.
