KitchenAid 720-0787 Instrucciones De Instalación Y Manual De Uso Y Cuidado página 18

_,_n L_!_ _-_ _ _ _ __
E×plosion Hazard
Use a new CSA International approved "outdoor"
gas supply line.
Securely tighten all gas connections.
Failure to do so can result in death,, e×plosion, or fire.
Installation of the regulator
1. Turn off the main gas supply valve.
2. Disconnect 20 Ib LP gas fuel tank (if present).
3. Turn off all burner control valves.
4. Remove the 20 Ib LP gas fuel tank (if present) from the grill cart.
5. Use an adjustable wrench to remove the LP regulator from the
manifold.
/
//
/
j_
Make Gas Connection
1. A combination of pipe fittings must be used to connect the grill
to the existing gas line.
• The 10 ft (3.0 m) PVC flexible gas supply hose design certified
by CSA must be used.
• Pipe-joint compounds suitable for use with Natural gas
must be used. Do not use Teflon®+ tape.
• There must be a certified manual shut-off valve in the gas
supply line near the grill for easy access.
2. Use a pipe wrench to connect the brass connector on one end
of the 10 ft (3.0 m) PVC flexible gas supply hose to the Natural
gas pressure regulator.
3. Connect the quick connector on the other end of the
10 ft (3.0 m) PVC flexible gas supply hose to the rigid Natural gas
supply pipe. To use the quick connect fitting; pull the head of the
quick connect back, insert the end of the PVC gas hose and
release the head of the connector. Check the connection and
make sure it is secure.
A
B
\\ \
C
6. Use an adjustable wrench to install the Natural gas
regulator hose to the manifold and secure. Attach the
Natural gas regulator to the side panel inside the grill cart
with the two screws that are pre-assembled on the
regulator.
_\\\\\
A. Manifold
B. Right side panel
C. 10 ft. (3.0 m) PVC gas hose
D. Natural gas pressure regulator/hose assembly
1- ®Teflon is a registered trademark of E.I. Du Pont De Nemours
and Company.