Nussbaum TTC 600 Manual De Instrucciones página 41

(1*/,6+ ‡ ,QVWUXFWLRQV PDQXDO
2) Lubricate both beads and the rim with tyre manufacturer recommended lu-
bricant.
3) Attach the PC clip to the outside edge of the rim at the highest point (See
Fig. M).
CAUTION!
Make sure the clip is firmly attached to the rim.
4) Take the mobile control unit to work position B.
5) Put the tyre on the platform and lower the spindle (make sure the clip is at
the high point).
6) Lift the rim with the tyre hook to it and turn it anticlockwise about 15-20
cm.
The tyre will be positioned tilted across the rim.
7) Take the mobile control unit to work position C.
8) Position the bead loosener disk against the second bead of the tyre and turn
the spindle until the clip is at the low point (at 6 o'clock).
9) Move the disk away from the wheel.
10) Remove the clip and replace it at 6 o'clock outside the second bead (See
Fig. N).
11) Turn the spindle clockwise 90° to bring the clip to 9 o'clock.
12) Move the disk forward until it is about 1-2 cm inside the edge of the rim.
Begin to turn the spindle clockwise checking to make sure that, with a 90° turn,
the second bead begins to slip into the centre well.
13) When the bead is fully mounted, move the tool away from the wheel, tip it
to its non-working position and remove the clip.
14) Position the platform under the wheel, lower the spindle until the wheel rests on the platform.
15) Take the mobile control unit to work position B.
16) Close the arms of the spindle completely. Support the wheel to prevent it falling off.
DANGER!
This operation can be extremely dangerous.
Do it manually only if you are certain you can keep the wheel balanced.
For large and heavy tyres an adequate lifting device must be used.
17) Move the platform to remove the wheel from the spindle.
18) Remove the wheel.
NB: If the tyre permits it, the operation described above can be speeded up by mounting both beads at the same time:
- Follow the steps described under points 1-5 described above but instead of attaching the clip to just the first bead (refer to point 5)
clip it to both.
- Lift the rim with the tyre hooked to it and turn it anticlockwise 15-20 cm (clip at 10 o'clock).
- Follow the steps described in points 12-18 above.
41
M
N
TTC 600