Idiomas disponibles
Idiomas disponibles
09 - DEFINITIONS OF CARD TYPES (AFTER ENROLLMENT)
ENROLL - Master card used to register fingerprints and user card.
DELETE - Master card used to delete fingerprints and user card.
USER - User card used for access.
PROG - Programming card of the reader menus.
10 - OPERATION OF THE READER WHEN CONNECTING THE POWER SUPPLY
When powering the reader for the first time, you may be asked to enroll the master cards, as shown in the following
menu. If the cards are already enrolled, the reader will emit 3 beeps and the blue LED will remain on.
11 - ENROLL MASTER CARDS (ENROLL, DELETE AND PROG)
Before enrolling users, it is necessary to register the "ENROLL", "DELETE" and "PROG" cards. These cards are used
as the "master" cards for inclusion/exclusion of user cards/fingerprints and other reader settings.
Swipe the card
"ENROLL"
to start
Initial status:
The green LED
Blue LED
lights up and 4
flashing
short beeps are
12 - ENROLL USER FINGERPRINTS
To enroll a user's fingerprint, follow the image below. The two fingerprints are linked to a single user ID. After com-
pleting the enrollment, continue with a new enrollment or swipe the "ENROLL" card to save and exit.
NOTES: While enrolling, if the red LED flashes with two beeps, it means that the user's fingerprint is already regis-
tered.
Swipe the card
"ENROLL"
to start
The
blue LED
will flash
Red LED
flashing
emitted
Continue enrolling new users
Continue enrolling the 2nd fingerprint
Place the
1st / 2nd
finger
The blue LED will
flash quickly and the
light of the biometric
sensor will turn on
Swipe the card
"DELETE"
to proceed
The green LED
lights up and
4 short beeps
are emitted
Place the
1st / 2nd finger
again
The green LED
lights up and 4 short
beeps
are emitted indicating
success in the operation
ENGLISH
Swipe the card
"PROG"
to close
Orange LED
The green LED
flashing
lights up and
4 short beeps
Swipe the card
Pass the
card
1 more time to
"ENROLL"
1 time to
the enrollment
confirm
enrollment
are emitted
"ENROLL"
end and exit
mode
27
