Idiomas disponibles
Idiomas disponibles
07 - EXAMPLE CONNECTION WITH RMF3004 RECEPTOR (SLAVE READER MODE)
ATTENTION: The example below refers to the installation with the RMF3004 Receiver, however, it applies to other
compatible Nice controllers, provided that it obeys the installation form contained in the manual of the equipment
used.
WeGo Bio
1 2 3 4 5 6
1 2 3 4 5
NOTES: For connection of door sensor, exit button, etc., refer to the manual of the receiver or controller used.
08 - FINGER POSITIONING INSTRUCTIONS ON THE BIOMETRIC SENSOR
- CORRECT MODE
Place the finger over the sensor so that it covers the entire surface of the sensor with slight downward pressure.
Always place the finger
in the center of the sensor.
- INCORRECT MODE
DO NOT move
the
the finger away
finger before the
from the center
backlight of the
sensor turns off.
26
1 2 3 4
Do NOT place
Do NOT place
the finger at an
of the
sensor area.
-
+
Power Source
12VDC / 1A
-
Be sure to cover the entire surface of the
sensor with as much of the finger as possi-
Do NOT remove
the finger during
angle.
the fingerprint
verification
process.
ENGLISH
RMF3004 Receiver
1 2 3 4 5 6
+
ble.
Do NOT use
only the
tip of the
finger.
Do NOT slide
the
finger during the
fingerprint
verification
process
