cecotec AIRCLIMA 9000 SMARTFRESH Manual De Instrucciones página 115

21. ANTI-MILDEW function
Press the
button to activate the anti-mould function and
will appear on the display. Do it again to deactivate this function. After running COOL/DRY
for more than 30 minutes, you can activate this function, the unit blows the airflow for 15
minutes to dry the internal parts to prevent mould, then stop the unit.
NOTE: The anti-mould function is only available in DRY (DEHUMIDIFICATION)/COOL (COOL)
mode.
Remote control
Battery replacement. Fig. 22
- Remove the battery cover from the back of the remote control by sliding it in the direction
of the arrow shown in the figure. Install the batteries according to the polarity (+/-)
shown on the remote control. Reinstall the battery cover by sliding it back into place.
- Use 2 x LRO3 AAA (1.5 V) batteries.
- Do not use rechargeable batteries.
- Replace old batteries with new ones of the same type when the display is no longer
readable.
- Do not dispose of batteries as unsorted municipal waste.
- This waste must be collected separately for special treatment.
For some models, each time you insert the batteries into the remote control for the first time,
you can set the control type to cooling only or heating pump. As soon as the batteries are
inserted, switch off the remote control and operate as follows.
1. Press and hold the
button until the
2.
icon flashes, to set the cooling only control type.
3.
4. Press and hold the
button until the
5.
icon flashes to set the heating pump type.
6.
For some remote control models, you can program the temperature display between ºC and
ºF.
1. Press and hold the
button for 5 seconds to enter switching mode.
2.
3. Press and hold the
button until it changes to ºC and ºF.
4.
5. Then release the key and wait 5 seconds, the function will be selected.
AIRCLIMA 9000 SMARTFRESH/ AIRCLIMA 12000 SMARTFRESH/ AIRCLIMA 18000 SMARTFRES/
AIRCLIMA 24000 SMARTFRESH/ AIRCLIMA 12000 SMARTFRESH CONNECTED
ENGLISH
115