Medela Symphony Manual Del Usuario página 11

5. Preparing for pumping (cont.)
Installation of the card and cord protector (optional):
1. Insert the cord into the card and cord protector in a loop around the pin ( ¢ 3-02).
Æ Ensure that there is sufficient cord length to insert the power cord into the power socket in the back of
the pump.
2. Push the card and cord protector over the guide rail on the back until it stops and tighten the screw
( ¢ 3-03).
3. To remove, unscrew the card and cord protector and slide out of the guide rail ( ¢ 3-04).
5.2 Mains operation
1. Insert the power cord into the power socket on the back of the pump ( ¢ 3-05). Plug the power cord
into the mains socket.
5.3 Assembling the Symphony pump set
CAUTION
• Wash hands thoroughly (at least one minute) with soap and water before touching the breast, the clean
pump and the clean pump set parts.
• Dry your hands with a fresh towel or a single-use paper towel.
NOTICE
• Use Medela original accessories only.
• Refer to instructions for use provided with the Symphony pump set for description and instruction on
handling the pump set.
5.4 Connecting the pump set to the pump housing
1. Open the lid of the breast pump: press the oval button on the top of the Symphony pump and lift the
handle ( ¢ 3-06).
2. Position the Symphony cap firmly on the breast pump membrane to form a seal.
Æ Make sure that the Symphony cap engages and lies flush to the surface ( ¢ 3-07).
3. Centre the tubing connector in the recess in the pump housing ( ¢ 3-07).
i
Information
Always close the lid when pumping. The lid keeps the membrane cap pushed down to prevent a loss of
vacuum that could occur if the membrane cap came off.
4. Close the lid ( ¢ 3-08).
11