HOLZMANN MASCHINEN HBS 245HQ Manual De Instrucciones página 37

14.3.2 Rip fence (Fig.q)
 The rip fence can be used on both side of the blade
 When the rip fence is moved from one side of the saw blade to other the fence needs to
reverse.
 To reversing the fence loosen and remove the two knobs (1q)
 Take off the fence with bolts from the fence support
 Assemble the fence with bolts to other side of the fence support.
 Replace the two knobs (1q)
 To clamp the rip fence (Fig.r) lock the lever (1r), move the fence to the needed position
and retighten the lever
 To adjust the height (Fig.s), loosen the two knobs (1q), rotate the fence 90° and retighten
the knobs
 To adjust the paralleling with the side of the bade (Fig.s), loose the two socket bolts (1s),
correct the position and retighten the bolts
14.3.3 Mitter gauge (Fig.t)
 The miter gauge is inserting into the table slot from the table front edge (1t)
 For miter cuts, the miter gauge can be turned to 60º in both directions
 To set a miter gauge, loosen the lock handle (2t) turn the an gauge to the needed position
and retighten the lock handle
14.3.4 Push stick
The push stick protects against contact with the band saw blade
 The push stick must be used if the distance
between band saw blade and a rip fence is less
than 150mm
 When the push stick is not used, it can be stored
on the hook provided at the band saw frame
 Replace push stick if damaged
14.3.5 Sawing
 Set upper blade guide 3mm above the workpiece.
 Place workpiece on the table.
 Plug in.
 Start saw.
 Cut workpiece in a single pass.
 Switch off if no further cutting is to be done immediately afterwards.
14.3.6 Dust collector
The band saw provides a dust port (Fig.u;1u). It should be connected with dust collector when
sawing wood.
If you do not have dedicated band saw extraction, there is another chance to get rid of the saw
dust. Most of debris except usual dust drifts would fall through a grating into the dust drawer
(Fig.v; 1v). It can be easily pulled out and cleaned.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
W A R N U N G
OPERATION
37
HBS 245HQ