Mounting Rip Fence; Operation Instructions - HOLZMANN MASCHINEN TK305 Manual De Intrucciones

16.2.1 Mounting rip fence

1. Pull out the "L" shape and black color stopper of rip fence.
2. Screw off these two of
dentation columns screw caps.
3. Hold the "Rip fence"; When the
fence "U-shaped slot" with the
small nut of the "Table
orientation plate groupware" in
a straight line, Please insert
the small nut along the U-
shaped slot to "rip fence".
ATTENTION: The top hole is
wider than the under hole.
4. Tighten up the dentation columns
screw.
5. Resetting the "L" shape and black color
stopper.
6. Insert the assemblies into the "U shape
of the working table face.
7. Adjust 90°
17 OPERATION
Device to be operated in a perfect state only. Inspect the device visually every time it is to be used.
Check in particular the safety equipment, electrical controls, electric cables and screwed connection
for damage and if tightened properly. Replace any damaged parts before operating the device.

17.1 Operation instructions

 Never switch the machine on while pressing the blade against the material!
 Start cutting only when the saw blade has reached the appropriate speed!
 Keep an eye on vibrations, unusual noises and movements. Stop operation
when abnormalities immediately!

Never remove debris and other parts of the workpiece during saw blade is
running
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
A t t e n t i o n
OPERATION
34
TK 305