Onkyo T-4500 Manual De Instrucciones página 4

FM Antenna Connections
Use the T-shaped antennaif you live in an area where signal strength
of FM broadcasts is high. Connect the antenna to the FM 75 ohms
terminals and place the antenna on a wall or other surface in the
position in which reception is best. If signal strength is low in your
area, use a multi-element FM outdoor antenna. Consult your Onkyo
authorized service center about the right type of antenna for your
area.
NOTES:
1. Do not connect both the indoor T-shaped antenna and an
outdoor FM antenna. If you decide to install an outdoor
antenna, be sure to disconnect the indoor T-shaped antenna.
Do not use the same antenna for both FM and TV reception
since the FM and TV signals can interfere with each other.
If you must use acommon FM/TV antenna, use a directional
linkage type splitter.
Direcrional linkage
type splitter
To tuner To TV (or VCR)
AM Antenna Connections
An AM loop antenna is included in the installation instructions bag.
Take out the connection line and connect it to the AM antenna
terminals. This loop antenna can be used placed on top of the tuner
or attached to a wall or other surface. Try several positions to
determine which gives the best reception. Be sure the antenna is
not near a speaker, power cord, television set, VCR, or motorized
appliances. When using an external AM antenna, do not revome
the loop antenna; connect both antennas to the AM antenna ter-
minals.
AM loop antenna assembly
Connect to the AM
antenna terminals
Remove the vinyl tie and
take out the connection
: Bend in the reverse
line
direction
®
a. With the antenna on
top of any stable surface
LLY
Mount on a wail, etc.
RI Remote Control jack ( RI : Remote Interactive)
For remote control operation, connect this jack and any Onkyo
amplifier bearing the " (RI " mark using the remote control cable
included with this unit.(Station Up/Down buttons can be controlled
via remote control.) For more details, see the user's manual for the
amplifier.
NOTE:
The FRE mark is Onkyo's own mark. Audio equipment with
this mark can be controlled through the amplifier with the
fR1 mark, using remote control transmitter. Do not connect
any product to this jack that does not have the Onkyo RI
mark. Doing so can damage your equipment.