TROUBLESHOOTING
Symptom
Possible cause
No power.
@
Power plug is disconnected from power outlet.
@
Plug in power cord correctly.
@
Power switch is set to OFF.
@ Set switch to ON.
No sound.
@
Connector plugs have become unfastened from
@
Connect cords correctly.
their jacks, or are connected incorrectly.
e@ Your stereo amplifier's "input selector" is set to
®
Set amplifier's input selector correctly.
the wrong position for the component to be
played.
@
You are operating other components incorrectly.
@
Consult the Operating Instructions for your
other components.
Sound only from speaker
| @ One side of your connector cords or speaker wires|
@
Connect cords and speaker wires securely.
on one side.
is disconnected.
No sound from Tape 2/AUX.|
@ The Direct button is in the ON position.
@ Set to OFF.
Remote control unit does
| @
No batteries, or dead batteries in the remote
@
Load new batteries in remote control unit.
not operate.
control unit.
@ You are trying to use the remote control unit from | @ The remote control unit can be used within a
too far away, or from a bad angle.
distance of 7 meters, and within an angle of
30° to right and left of the ampilifier's front
surface.
@ An obstructing object is between the remote
@
Change the position from which you operate
control unit and the amplifier.
the remote control unit, or remove the
obstructing object.
@ The system control cables or audio cables are not | @ Connect properly.
connected properly.
@ A fluorescent lamp is shining too close to the
@
Remove the fluorescent lamp farther away
signal receiver.
from the signal receiver.
This unit may also malfunction as the result of a nearby lightning strike, static electricity, or other external influences. In this event, turn
off the power switch and then turn back on again, or disconnect the power cord and then reconnect.
36
<ARE7009>
En
