Adjustment
of Cutting Width
When cutting width is too narrow
or too wide against
seam width, adjust it as follows.
1. Turn off the power switch and unplug the
machine.
2. Open the looper cover and side cover.
3. Set the upper knife to down position
4. Turn the cutting
width adjusting
dial to get
desired
position
of lower knife.
(_
Cutting width adjusting dial
Lower knife
(_
Standard setting
....
* The cutting
width of this mod
approximately
3.0 to 5.0 mr ..................................................................................
needle position
depending
:_
your sewin_
:
needs or the fabric ......
being
....
(The cutting
to g
.............
same
When cuttin_:wiath
is too na_ro
......
Turn cutting
i : Iockwise
(A).
Lower knife iii : : to
When cutting width is too wide.
Turn the cutting width adjusting
dial counterclockwise
(a).
Lower knife will move to left.
5. Set the upper knife to up position.
6. Close the looper cover and side cover.
L
/./
/JJ(_
//
J
20
